Avidyne IFD540 Manual de Instalação descarregar pdf (Página 49)

FMS Pages 2-11

ADDING A VERTICAL CONSTRAINT

On virtually every waypoint, you can elect to assign a vertical

constraint (e.g. cross the waypoint at or above a specific altitude,

be at a specific altitude a specified distance prior to the waypoint,

etc). This is accomplished by ensuring an edit cursor surrounds

the waypoint of interest to select the waypoint and then either use

the bottom right inner knob or touch the desired field to highlight

one of the vertical constraint fields of the flight plan leg. Push the

knob and enter the desired value or double tap the field to display

a virtual keypad. This can be accomplished at any time on the

ground or in-air.

Vertical Constraint Choices

Cross

Type

Altitude

Number field

(selecting distance

in NM from

waypoint for

crossing constraint)

At Or Below;

At;

At or Above.

Altitude field

(selecting the target

altitude). Minimum

allowable value is

100’.

Vertical Constraint Fields

The default value for the crossing distance is 5.0nm for airports

and 0.0nm for all other waypoints.

The only waypoints that do not permit vertical constraints are:

Origin

Destination, if it has an approach selected

Missed Approach Point

Altitude Terminated Legs

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 225 226

Sem comentários

Avidyne IFD540 Manual de Instalação Página 49